Keysight U1271A - Page 18

18 Keysight U1271A/U1272A Quick Start Guide
18 Keysight U1271A/U1272A Quick Start Guide
ENGLISH
Current measurements
Set up your multimeter as shown in the figure
below to perform current measurements. Press
to switch between AC, DC, AC+DC, or %
scale current measurements. When measuring
DC current from a mixed signal in DC
measurement mode, ensure that the Filter ( ) is
enabled.
S
h
i
f
t
V
i
e
w
E
s
c
WARNING
Always use the proper function, range, and terminals
for current measurements. Set the positive input
terminal to the terminal for currents below
440 mA, and the terminal for currents above
440 mA.
AC
LOAD