Kia D9062 ADUP0 - Troubleshooting; Common Issues and Solutions

Genuine Accessories
Troubleshooting
Issue / Concern
Items to be Checked
Confirm constant power circuit is properly connected
Circuit should have 12V power with ignition in "OFF"
-Check that mirror harness is properly connected at mirror
-Check that T-tap is connected to the proper wire
-Check that T-Tap is fully crimped
-Check that male spade is correctly inserted in T-tap.
-Check that wire harness is not damaged
-Replace the mirror
-Replace the mirror
-Check that T-tap is connected to the proper wire
-Check that T-Tap is fully crimped
-Check that male spade is correctly inserted in T-tap
-Check that GND ring terminal is seated solidly against ground ring
-Check vehicle interior lamp fuse
Homelink does not work
(red LED does not illuminate)
↑
↑
-Check that T-tap is connected to the proper wire
-Check that T-Tap is fully crimped
-Check that male spade is correctly inserted in T-tap
-Check that GND ring terminal is seated solidly against ground ring
-Check vehicle interior lamp fuse
Confirm ignition-switched power circuit is properly connected
Circuit should NOT have power with ignition in "OFF", but should have
12V power when ignition is switched to "ON"
-Check that mirror harness is properly connected at mirror
-Check that T-tap is connected to the proper wire
-Check that T-tap is fully crimped
-Check that male spade is correctly inserted in T-tap
-Check that wire is not damaged
Confirm ground circuit is properly attached & tightened
-Check that mirror harness is properly connected at mirror
-Check that GND ring terminal is seated solidly against vehicle ground
ring
-Check that wire is not damaged
Homelink does not work
(red LED does not illuminate when any HL buttons pressed)
Auto-dimming function does not work properly
(green LED illuminates, but mirror does not darken)
Auto-dimming function does not work properly
(green LED does not illuminate)
Mirror does not power up
Compass does not illuminate
-Check that T-tap is connected to the proper wire
-Check that T-Tap is fully crimped
-Check that male spade is correctly inserted in T-tap
-Check that GND ring terminal is seated solidly against ground ring
-Check vehicle interior lamp fuse
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 16 of 17