Kia D9062 ADUP0 User Manual

Genuine Accessories
Glasses Gloves
Mask Hearing Protection
1 Read the entire Installation Instructions prior to beginning the installation of the part.
2 Make sure the vehicle is completely clean and dry in the area(s) the part is to be installed.
3 Ensure the vehicle is properly protected in the area(s) that the accessory is to be installed.
4 NEVER place tools on painted surfaces, seating surfaces, dash pad, console or floor carpet/mats.
5 Always wear appropriate personal protective equipment, including gloves, safety glasses, etc., when required.
6 Record radio presets prior to disconnecting battery power, if needed.
7 Ensure the transportation fuse is set to "ON" before starting the install.
8 Roll down the driver's window and adjust the power seats (if applicable) prior to disconnecting battery power, if needed.
Vehicle Model
D9062 ADUP0
Difficulty stated above reflects the minimum level of
expertise required to install the accessory:
( B )
Mirror, Auto-dim with HL4 Comp.
(A) Customer
Denotes cautions to be taken to avoid
vehicle and component damage
Denotes cautions to be taken to avoid
physical injury or electronic component
damage
Language
English
11/23/2015
Basic Required Tools
N
O
T
E
Denotes important information to be
reviewed during the step
Denotes specific tools that are necessary
to complete a step
T20 Torx Driver
Ratchet
Slotted Screwdriver
T20 Torx Socket
Notes to the installer:
10mm Socket
Nylon Panel Removal
Tool
#2 Phillips Screwdriver
Torque Wrench
Side Cutters
Pliers
Tape Measure
Denotes quality processes to be checked
prior to moving to the next step
Denotes personal protective equipment (PPEs) that
may be required for a step. Examples of safety
equipment icons noted below:
Denotes warnings that may lead to serious
physical injury or vehicle damage
Part No.
Model Year
Copy OEM Logo Here (→)
2017~
D9062 ADU00
Difficulty:
Note:
Rev. Date
Accessory:
Sportage
(C) Master Technician or Specialist
(B) Dealer Technician
Instructional Symbols / Definitions
M10
T20
T20
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 1 of 17

Kia D9062 ADUP0 Specifications

General

Brand	Kia
Model	D9062 ADUP0
Category	Automobile Accessories
Language	English

Summary

Introduction and Preparation

Instructional Symbols and Definitions

Explains warning, caution, and information symbols used in the manual.

Basic Required Tools

Lists essential tools needed for the installation process.

Installer Notes

Provides important notes and precautions for the installer.

Kit Overview

Electrical Connection Procedure

Electrical Connection Procedure Details

Details wire appearance, connector diagrams, and T-Tap installation.

Installation and Assembly Steps

A-Pillar Trim Panel Removal

Instructions for removing the A-pillar trim panel.

Mirror and Overhead Console Removal

Steps for removing the existing mirror and overhead console.

Lower Dash Trim and Mirror Installation

Guides for removing lower dash trim and installing the new mirror.

Harness Routing and Connections

Details on routing the mirror harness and making electrical connections.

Ground Connection and Battery Preparation

Procedure for making the ground connection and preparing the battery.

Function Checks

Tests to verify the correct operation of the installed accessory.

Vehicle Reassembly and Calibration

Instructions for reassembling the vehicle and calibrating the compass.

Post-Installation Checks

Visual Check List

Checklist to verify all components are correctly installed and secured.

Troubleshooting

Common Issues and Solutions

Addresses common problems and provides solutions for the accessory.

Wiring Diagram