Kia D9062 ADUP0 - Harness Routing and Connections

Genuine Accessories
1. Wrap one (1) foam tape around the mirror harness connector, as shown.
N
O
T
E
1. Plug the 5-pin connector from the provided one (1) mirror harness into
the harness lead extending out from the mirror.
N
O
T
E
17
18
CAUTION: Ensure 5-pin connector is securely installed.
19
Nylon Panel Removal Tool
20
N
O
T
E
1. Begin tucking the mirror harness between the headliner and the
roof. Stop after the foam-taped harness connector is hidden
under the headliner.
N
O
T
E
1. Slide the provided one (1) wire cover over the mirror harness lead,
and click it into the top surface of the mirror base.
2. Extend the upper wire cover until it hooks onto the headliner.
Ensure the cover is vertical.
CAUTION: Use caution when working with the headliner to
prevent creases or damage. Make sure hands are clean.
CAUTION: Ensure cover "forks" are properly seated into mirror
and headliner.
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 8 of 17