Kia e-niro - Page 17

15
Emergency Procedures
2. If necessary, lower the windows, unlock the doors and open the tail gate as required,
before disconnecting the 12V battery. Once the 12V battery is disconnected, power
controls will not operate.
3. Before disconnecting 12V battery, remove the Smart Key at least 2 meters away
from the vehicle to prevent accidental restart.
4. Use the following procedure to remove the safety plug
and disable the high voltage battery:
b) Remove the service plug
cover (A)
after removing rear seat cushion assembly.
a)
Disconnect 12V auxiliary batter negative
(-) terminal.
c) Remove the service plug (A).
5. In case of emergency, cut the service interlock connector
cable to isolate the high voltage of the battery.