Kia niro 2023 - Blind-Spot Collision Warning (BCW)

49
6
6
Driving your vehicle Blind-Spot Collision Warning (BCW)
Blind-Spot Collision Warning
(BCW) (if equipped)
Blind-Spot Collision Warning uses rear
corner radar sensors in the rear bumper
to monitor and warn the driver of an
approaching vehicle in the driver's blind
spot area.
1. Blind-Spot Area
It warns by detecting the vehicles in the
blind spots.
The blind spot detection range varies
relative to vehicle speed.
Note that if your vehicle is traveling
much faster than the vehicles around
you, the warning will not occur.
2. Closing at high speed
Blind-Spot Collision Warning will warn
you when a vehicle is approaching in an
adjacent lane at a high rate of speed. If
the driver activates the turn signal when
the function detects an oncoming vehi
-
cle, the function sounds an audible warn.
WARNING
僅 Blind-Spot Collision Warning is a sup -
plemental function to assist you. Do
not entirely rely on the function.
Always pay attention, while driving,
for your safety.
僅 Always be aware of road conditions
while driving and be warn for unex -
pected situations even though Blind-
Spot Collision Warning is operating.
僅 Blind-Spot Collision Warning is not a
substitute for proper and safe driving.
Always drive safely and use caution
when changing lanes or backing up
the vehicle. Blind-Spot Collision Warn
-
ing may not detect every object
alongside the vehicle.
Blind-Spot Collision Warning set -
ting and activation
Settings
僅 The driver can activate the function
by placing the vehicle to the ON posi -
tion.
僅 If you press the Blind-Spot Safety but
-
ton the indicator on the button extin -
guishes and the function deactivates.
僅 If you press the Blind-Spot Safety but -
ton while the function is canceled the
indicator on the button appears and
the function activates. In this case, the
function returns to the state before
the vehicle turned off. When the func
-
tion is initially turned on and when the
motor is turned off then on again
OSG2H051030
OSG2H051031
ODEPV052093