SOUL FEATURES & FUNCTIONS GUIDE
20
*IF EQUIPPED
STEERING WHEEL CONTROLS
B
C
G
A
B
Smart Cruise Control
canceled
E
D
H
Smart Cruise Control
Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website.
Refer to page 2 for more
information.
www.youtube.com/KiaFeatureVideos
QR CODE
172ft 130ft
82ft
106ft
(Vehicle-to-vehicle distance settings;
may vary per vehicle)
Smart Cruise Control (SCC)*
The Smart Cruise Control (SCC)* system allows you to set the vehicle to maintain a
speed so long as it is not limited by traffic. When traffic is encountered, the vehicle
will be slowed to maintain a set distance behind traffic without depressing the
accelerator or brake pedal.
To set/adjust the SCC speed:
• Push the CRUISE button
A
to turn system ON. The CRUISE indicator will
illuminate on the instrument cluster
• Accelerate/decelerate to the desired speed and press the RES+ / SET– buttons
B
To set the vehicle-to-vehicle distance, press the SCC button
C
on the steering wheel.
The images on the LCD screen
D
and the Instrument Cluster
E
will change when
scrolling through the settings. Each time the button is pressed, the vehicle-to-vehicle
distance changes.
To cancel SCC operation: Press the CANCEL button
G
. The LCD screen will display
a message that the SCC operation is canceled
H
.
To turn SCC system OFF: Press the CRUISE button
A
. The CRUISE indicator on the
instrument cluster will turn OFF.
To change the Cruise Control mode from SCC to standard Cruise
Control, press and hold button
A
. Repeat to switch modes again
(The SCC system must not be activated to change modes).
For the SCC System to operate:
• When no vehicle is in front, you must be travelling at a
minimum speed of 19 mph
• When following a vehicle, there is no minimum speed
requirement
When following a vehicle, the system will automatically adjust
your cruise speed based on the vehicle in front. It will even bring
the vehicle to a complete stop if necessary.
QUICK TIPS
REMINDERS:
• Cruise Control button must be ON in order to turn SCC ON/OFF
• SCC system is activated when ignition is turned on. Speed will
need to be reset when ignition is cycled on
• The distance settings are approximations and may vary depending
on factory settings at the time. See owner’s manual for more
information
• In standard Cruise Control, the driver needs to manually assess
the distance from other vehicles as the system will not apply
brakes to slow down automatically in order to turn SCC ON/OFF
• The SCC is also canceled when the driver’s door is opened, gear
shift is changed out of D (Drive) and various other conditions. See
owner’s manual for other conditions.
To Next Page
Loading...
Need help?
General
