Kichler Lighting Terra Select - Downrod and Hanger Ball Assembly

HANGING THE FAN
Step 6. Loosen the two set screws and remove the hitch pin and retaining clip from
the coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up through the
downrod. Thread the downrod into the coupling until the Hitch pin holes are
aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 8)
Step 8. Slip the coupling cover, canopy cover and canopy onto the downrod.
Thread the hanger ball onto the downrod, insert the cross pin through the
downrod and tighten. Now tighten the set screw. (Fig. 9)
Downrod
Coupling cover
Canopy cover
Canopy
Fig. 8
Supply wires
Set screw
Set screw
Retaining clip
Hitch pin
Downrod
Fig. 9
Retaining clip
Hitch pin
Set screw
8 | KICHLER.COM