7
„ The KickAss Charger has been engineered to charge 12 Volt GEL, AGM, WET,
CALCIUM or Lithium LiFePO only. Do not use this charger for any other purpose or
4
with any other battery types.
„ Do not attempt to charge known faulty, damaged, frozen or broken batteries.
„ Ensure charger is close to battery, however never mount the charger directly on the
battery.
„ Ventilation is very important in battery charging, always ensure battery positioning is
in a well ventilated area to allow charging gases to dissipate.
„ Keep sparks or flames away from batteries being charged as they could emit
explosive gases.
„ Always check the batteries and charging system periodically to ensure no faults
occur.
„ Ensure all cabling is secure and cannot be cut, broken or short circuited.
„ Battery acid is corrosive. If acid comes into contact with skin or eyes, please seek
medical advice.
„ Never connect this charger to mains supply.
„ We recommend fitting a 50-75 amp fuse on both the input and output sides of the
charger such as the SKU: KAMAXIFHAND or SKU: KAFUSECOVER-KIT to protect
cables from short circuits etc.
MOUNTING
It is most important to mount your KickAss Charger as close as possible to your auxiliary
battery and be sure to keep your charger away from sources of heat. eg. Turbos and
exhaust pipes. This will ensure maximum performance out of your charger.
SAFETY FIRST!
INSTALLATION GUIDE
To Next Page
Loading...
