Kicker 19417166 - Connections

2
Fig. 5
1. Disconnect negative battery cable.
2. Remove the cover of the battery junction box. Fig. 1
3. Make sure supplied fuse is not installed in fuse holder and connect the subwoofer and amplifier
power wires to the studs pictured in figure 2. Either wire can go to either stud Torque to 4.7Nm
(42in-lb)
4. Route the power wires toward the firewall and secure with supplied wire ties.
5. Find the rubber grommet behind the battery and cut the end of the accessory tube. Feed the
power wires through the grommet tube into the cabin. Fig. 3
6. Install the white three pin power connectors on each power wire. Close the retainer.
Fig. 4
NOTE: Do not mix terminals from power wires between connectors. Make sure
all three wires from each power wire are each in a single connector.
7. Connect one power wire to the subwoofer
harness and one to the amplifier harness. Fig. 5
Fig. 1
Connect one power
harness to each
terminal
Fig. 2
Then
close
retainer
Insert terminals first.
Any wire can be in
any position.
Fig. 4
Fig. 3