2
KMT67 Long-Range Tower System
Owner’s Manual
INSTALLATION
Mounting: The sound produced by the KMT67 long-range tower system is directional. The enclosure may
be mounted vertically or horizontally; the billet-aluminum mounting brackets can accommodate any angle for
the optimum fi ring direction. Find the best location for stereophonic sound and, if necessary, add more KMT67
systems to the installation to help distribute and balance the sound. After determining the best mounting
locations, carefully check the areas where the mounting hardware and speaker cable will be placed. The KMT67
long-range tower system’s billet-aluminum mounting brackets use seven sets of ABS plastic inserts to fi t most
wakeboarding tower and roll bar diameters.
The mounting hardware design provides versatility in angular positioning to direct the speaker’s output to the
ideal listening position; however, it is not recommended to reposition the speakers excessively after they are
mounted. Custom mounting locations will require more preparation, work, and possibly customized hardware. If
the mounting location requires you to cut metal, avoid structural metal and braces. In either case, make sure the
speaker will not interfere with the vehicle’s mechanisms or the party you are throwing out on your pontoon boat.
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
Model: KMT67
Woofer [in, mm] 6-3/4, 165
Tweeter [in, mm] 3/4, 20
Dome Material Titanium
Exponential Horn [in, mm] 3-1/4x6, 83x151
Rated Impedance [Ω] 4
Peak Power Handling [Watts] 300
Continuous Power Handling [Watts RMS] 150
Sensitivity [1W, 1m] 93dB
Frequency Response [Hz] 50–21k
Height [in, mm] 9, 229
Width [in, mm] 19-1/16, 484
Depth [in, mm] 11, 280
MODEL: KMT67
The KICKER KMT67 Long-Range Tower System is specifi cally designed for mounting in the open-air, using an
exponential-horn-loaded 20mm titanium tweeter and dual 6.75 inch (165mm) woofers to produce clean and
crisp sound over a long distance. The injection-molded ABS enclosure and speakers are UV treated, splash
resistant, and weather resilient. The woofers utilize a sealed cone and motor assembly, and an open-cell foam
protects the tweeter. Mount the KMT67 in your boat or get creative with a pair of them in the garage, on your 4x4
or side-by-side roll bars, or in any other bar-mounted application.
2014 KMT67 Rev D.indd 22014 KMT67 Rev D.indd 2 8/8/2013 4:26:53 PM8/8/2013 4:26:53 PM
To Next Page
Loading...
Need help?
General
