4
RSCOMPONENTSYSTEM
CROSSOVER CONFIGURATION
The KICKER RS crossover can be confi gured as a conventional 2-way crossover by installing the included
INPUT jumper into the - MID + -TW + input terminals as shown in Fig. 2. In this confi guration, the
amplifi ed signal from your source unit or amplifi er should be wired to the + and - terminals indicated on the
INPUT jumper.
The RS crossover can also be confi gured for bi-amp wiring by removing (or simply not installing) the
INPUT jumper. To use the bi-amp confi guration, you must connect two amplifi ed signals to each
crossover (you will need at least four amplifi er channels). Set the tweeter output-level switch to 0 dB, +3
dB, or +6 dB. Higher switch settings will result in more volume from the tweeter.
Step 1 Step 2
Steps 3–6
Steps 7–8
tweeter
boot
coaxial mounting post
tweeter lead
wires
RS crossover
INPUT
-MID+-MID+
INPUT OUTPUTOUTPUT
-TW+-TW+
-
+
+
6 +3 +0
INPUT jumper.
Install only for 2-way confi gurations;
do not install if bi-amping.
tweeter output-level switch.
Higher switch settings mean
more volume from the tweeter.
Fig. 2
Fig. 1
Confi guring the RS
for Coaxial Operation
2009 RS Multilingual f01.indd 42009 RS Multilingual f01.indd 4 11/21/2008 10:57:25 AM11/21/2008 10:57:25 AM
To Next Page
Loading...
