Need help?Do you have a question about the Kicker ZX100.2 and is the answer not in the manual?
General| Brand | Kicker |
|---|---|
| Model | ZX100.2 |
| Category | Car Amplifier |
| Language | English |
Choose a structurally sound location, drill holes, and mount the amplifier securely with screws.
Connect ground, power, and signal wires, keeping signal cables away from power wiring for optimal performance.
Diagrams illustrate common stereo and mono operation setups for the amplifier.
Lists key technical specifications including RMS power, dimensions, frequency response, and signal-to-noise ratio.
Select from +12V, DC Offset, or Audio modes for automatic amplifier turn-on.
Configure input level (Hi/Low) and internal crossover (OFF, HI, LO) for desired signal path.
Adjust input gain to match source and use bass boost for enhanced low frequencies.
Diagnose no output, single channel failure, and protection mode activation.
Address alternator whine, ground noise, and stereo imaging problems.
Instructions for returning defective products for warranty service or repair.
Details damages and conditions not covered by the product warranty.
Contact local dealers for international warranty policies and safety advice.
To Next Page
