Need help?Do you have a question about the Kicker ZX500.1 and is the answer not in the manual?
General| RMS Power at 1 Ohm | 500W |
|---|---|
| Total RMS Power | 500W |
| Frequency Response | 20 Hz - 200 Hz |
| Signal-to-Noise Ratio | > 95 dB |
| Crossover Type | Low-pass |
| Bass Boost | 0-18dB @ 40 Hz |
| RMS Power at 2 Ohms | 250W |
| RMS Power at 4 Ohms | 125W |
| Crossover | 50Hz - 200Hz |
| Subsonic Filter | 25 Hz |
| Fuse Rating | 30A |
Instructions for structurally sound mounting and ventilation requirements for the amplifier.
Details on connecting ground, power, and signal wires, including input level switch settings and RCA connections.
Explains common configurations, focusing on one-channel operation and impedance requirements.
Table detailing RMS power output for ZX400.1, ZX500.1, and ZX750.1 models at different impedances.
Key common specs: length, height, width, frequency response, S/N ratio, input sensitivity, crossover, filter, and bass boost.
Explains three automatic turn-on modes: +12V, DC Offset, and Audio Signal Sense.
Guidance on setting input level and gain to match source unit output and avoid distortion.
Details on adjusting crossover, bass boost, and connecting the remote bass control.
Diagnosing no output with red badge off/on, flashing LEDs, and thermal/voltage protection.
Addressing low output, alternator noise, reduced bass response, and ground noise.
Steps for returning defective merchandise for warranty service, including RMA process.
List of non-covered damages, service time, and warranty validity.
Warning that Kicker products can produce sound levels that may permanently damage hearing.
To Next Page
