To Next PageTo Next Page
Need help?Do you have a question about the Kicker KX120.2 and is the answer not in the manual?
General| Brand | Kicker |
|---|---|
| Model | KX120.2 |
| Category | Car Amplifier |
| Language | English |
Features a radically advanced chassis with a removable shroud.
Stable into 2 ohm stereo or 4 ohm mono loads.
Protects amplifier from short circuit, over-voltage, reverse polarity, and thermal issues.
Provides high efficiency operation.
Variable bass boost circuit providing up to 18 dB of boost at 40 Hz.
12 dB High pass or Low pass, variable from 50-200 Hz, defeatable for full range.
Allows connection to various sources like aftermarket stereos, factory radios, DVD players.
RCA jacks to pass the incoming signal to another amplifier or component.
Assure maximum power transfer and damping.
Amplifier operates into a bridged mono load and a stereo load at the same time.
Warranty when purchased from and installed by an Authorized KICKER dealer.
Guide for selecting a location, removing the shroud, and securing the amplifier.
Using RCA or high-level inputs, and recommendations for cable routing to minimize noise.
Fuse size and wire gauge recommendations for amplifier power connections.
Sending signal to other components without Y cables.
Diagram showing stereo configuration for amplifier connections.
Diagram illustrating mono configuration for amplifier connections.
Diagram for simultaneous stereo and mono operation.
Setting the internal crossover for signal filtering (OFF, LO, HI).
Matching head unit output to amplifier input level for optimal performance.
Subjectively adjusting the crossover frequency to match listening preference.
Adjusting the KickBass low-frequency boost up to 18 dB at 40 Hz.
Interpreting LED status and diagnosing issues with no sound output.
Troubleshooting problems with one channel or low volume output.
Addressing alternator noise and poor stereo imaging or bass response.
Power output details at different impedances and voltages.
Length specifications with and without shroud.
Height, width, frequency response, input sensitivity, S/N ratio, and crossover details.
Details on warranty periods based on purchase and installation.
Steps for returning defective merchandise for warranty service.
Exclusions from warranty coverage, including installation and misuse.
Contacting international dealers for country-specific warranty policies.
