Kicker KX120.2 - Using Signal Output Jacks (PAST)

5
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to send the
incoming signal from one Kicker KX series amplifier to another amplifier or
processor without the need for Y cables. The signal from the PAST jacks is iden-
tical to the signal fed to the amplifier via its RCA input jacks or the High Level
inputs and is not affected by the amplifier’s built in crossover.
Most head units with high voltage outputs should be capable of driving up to
ten amplifiers in a chain.
SOURCE UNIT
To Next Amplifier or Processor
Left +
Left -
Right -
Right +
Speaker
Outputs
RCA
Outputs
WARNING - Use either the Hi-Level or RCA Inputs. Never Both !!