Need help?Do you have a question about the Kicker KX150.2 and is the answer not in the manual?
General| Brand | Kicker |
|---|---|
| Model | KX150.2 |
| Category | Car Amplifier |
| Language | English |
Record purchase details and attach the original sales receipt for future reference and warranty.
Congratulates the user on purchasing the latest KICKER amplifier technology.
Class A/B stable into 2 ohm stereo or 4 ohm mono loads for versatile speaker configurations.
Protects the amplifier from short circuit, over-voltage, reverse polarity, and thermal issues.
Provides high efficiency operation for reliable power delivery.
Variable bass boost circuit offering up to 18dB of boost at 40Hz.
Selectable 12dB High pass or Low pass from 50-200Hz, user defeatable for full range.
Allows connection to various sources like aftermarket stereos or factory radios.
Output RCA jacks (PRE Amp Signal Transfer) to pass signal to another amplifier or component.
Custom tooled gold plated connectors ensure maximum power transfer and secure clamping.
Stereo And Mono Simultaneously operation into bridged mono and stereo loads.
Cast aluminum, removable covers to protect and customize wiring connections.
Two year warranty provided when purchased from an Authorized KICKER dealer.
Select a structurally sound, well-ventilated location, considering heat and accessibility.
Procedure for removing EndKap, drilling holes, and mounting the amplifier using supplied screws.
Input signal via low level RCA or high level (speaker level) connections.
Connect ground wire first, keep it short, and use a paint/corrosion-free metal area.
Install a fuse within 18 inches of the battery to protect the power wire.
Use twisted pair interconnects and route cables away from other wiring at 90-degree angles.
Chart for fuse size and wire gauge recommendations based on amplifier model.
Diagram for stereo operation, minimum 2-ohm impedance, and speaker wiring configurations.
Diagram for bridged mono operation, requiring a minimum 4-ohm impedance.
Diagram for simultaneous stereo and mono operation with passive crossovers.
Utilize Output (Pre Amp Signal Transfer) RCA jacks to daisy-chain amplifiers or processors.
Overview of amplifier controls: three rotary controls and one switch on the end panel.
Setting the crossover switch (OFF, HI, LO) for full-range, high-pass, or subwoofer output.
Procedure for adjusting input gain to match head unit output for optimal performance.
Fine-tuning the crossover frequency (50Hz - 200Hz) to personal preference or speaker needs.
Using the KickBass control for 0-18dB boost at 40Hz, and adjusting gain to prevent clipping.
Interpreting green (on) and red (protection) LEDs, and power indicator badge status.
Troubleshooting steps for no output when Green LED is off, on, or Red LED is lit.
Diagnosing issues when only one channel has no output, checking connections and source.
Diagnosing and resolving alternator noise (whining sound tied to engine RPM).
Fixing poor stereo image or reduced bass response by checking phasing and wiring.
Important cautions regarding correct jumper cable connections to prevent damage.
Information on contacting Authorized KICKER Dealer or Technical Services for help.
Detailed RMS power output specifications for KX150.2, KX200.2, and KX250.2 amplifiers.
Common specifications including height, width, frequency response, input sensitivity, and crossover.
CEA-2006 compliance details including power, signal-to-noise ratio for each model.
Details Kicker's limited warranty for electronics, covering defects in material and workmanship.
Instructions for returning defective merchandise for warranty service to an Authorized Dealer or Kicker.
List of conditions and damages not covered by the Kicker warranty policy.
Information on Kicker's goal for 72-hour service turnaround time for electronics.
To Next Page
