Kidde 5CO - Installation Instructions: Mounting

9
5. Installaon Instrucons – Mounng
THIS ALARM MUST BE INSTALLED BY A COMPETENT PERSON AND IS TO BE INSTALLED
ACCORDING TO THESE INSTRUCTIONS
Wall-mounng
1. Drill two holes in a wall 7cm (2 3/8”) apart (you may wish to use the back-plate for
guidance)
2. Insert the two rawl-plugs, that are supplied, into the holes
3. Insert the two screws as supplied into the holes ensuring enough of the screw scks
out of the wall (approx. 3mm)
4. Hook the alarm over the screws
Free-standing
1. No more than 1 metre from the floor (to minimise this risk of the alarm being perma-
nently damaged should it be knocked to the floor from a greater height)
2. Make sure the alarm is in the upright posion and not lying flat on the surface