Testing
CAUTION: Due to the loudness (85 decibels) of the alarm, always
stand an arms length away from the unit when testing.
Test by pushing the Test button on the cover and hold it down
for a minimum of 5 seconds. This will sound the alarm if all the
electronic circuitry, horn and battery are working. If no alarm
sounds, the unit has a defective battery or some other failure. DO
NOT use an open flame to test your alarm, you could damage the
alarm or ignite combustible materials and start a fire.
Test the alarm weekly to ensure proper operation. Erratic or
low sound coming from your alarm may indicate a defective
alarm, and it should be returned for service (see Warranty
section).
Alarm Removal
To remove the alarm from the mounting plate, rotate the alarm in
the direction of the “OFF” arrow on the cover.
Maintenance
13
To Next Page
Loading...
