Kidde K10SCO - Other Alarm Visual and Audible Indicators

6
3. Other Alarm Visual and Audible Indicators
Operational Mode Visual Indications Audible Indications Action/Note:
Normal (standby) Green LED blinks approx every
30 sec.
Test (button press
when no alarm
condition is present)
• Test: Red LED blinks in sync with
beep pattern.
• “Push Test Button” when the unit
is powered up, reminding user to
activate the Test Button
• Button press sound
• 3 long beeps, voice "Fire! Fire",
3 long beeps, 4 quick beeps,
voice "Warning, Carbon
Monoxide," 4 quick beeps, single
beep.
Perform button press once
a week to verify proper
alarm operation.
Smoke or CO Alarm
Memory (unit has
experienced a smoke
or CO alarm event
within the last hour)
Red LED will ash every 30 sec. After button push, Sounds 3 beeps
when button is pressed. or
“Caution, Carbon Monoxide
previously detected.”
Push button to clear Alarm
Memory.
Smoke Alarm Hush
Mode
Red LED ashes 3 times, every
4 sec.
After button push,
voice: "Hush Mode Activated."
Smoke alarm pattern stops.
This feature is to be used
only when a known alarm
condition, such as smoke
from cooking, activates
the alarm.
Smoke Alarm Hush
Mode Canceled
None Voice message "Hush Mode
Canceled."
After 8-10 minutes, the
voice message will occur.
CO alarm reset None After button push: CO alarm
pattern stops.
Unit is conrming if CO is
present or if it experienced
a nuisance situation.
Re-alarm means danger.
Move to fresh air and call
0800 111 999.