7. Maintenance
Move the CO Alarm to a remote location, to prevent possible damage or
contamination of the sensor, prior to performing any of the following:
• Staining or stripping floors or furniture, painting or wall-papering,
• Using aerosols or adhesives
WARNING: Reinstall the CO Alarm as soon as possible to
assure continuous protection.
The following is a list of substances that at high levels can damage the
sensor or cause temporary readings that are not CO readings:
• Ethylene, ethanol, alcohol, iso-propanol, benzene, toluene, ethyl
acetate, hydrogen, hydrogen sulfide and sulfur dioxide.
• Also most aerosol sprays, alcohol based products, paint, thinner,
solvent, adhesive, hair spray, after shave, perfume, auto exhaust
(cold start) and some cleaning agents.
To Next Page
Loading...
