EasyManuals Logo
Home>Kidde>Security System>KN-COP-DP-10YB

Kidde KN-COP-DP-10YB User Manual

Kidde KN-COP-DP-10YB
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
7. Maintenance
• Avoid spraying air fresheners, hair spray, paint or other aerosols
near the alarm.
• Do not paint the unit. Paint will seal the vents and interfere with
proper sensor operation.
Move the CO Alarm to a remote location, to prevent possible
damage or contamination of the sensor, prior to performing any of
the following:
• Staining or stripping floors or furniture, painting or wall-papering
• Using aerosols or adhesives
WARNING: Reinstall the CO Alarm as soon as possible to assure
continuous protection.
The following is a list of substances that at high levels can damage
the sensor or cause temporary readings that are not CO readings:
• Ethylene, ethanol, alcohol, iso-propanol, benzene, toluene, ethyl
acetate, hydrogen, hydrogen sulfide and sulfur dioxide.
• Also most aerosol sprays, alcohol based products, paint, thinner,
solvent, adhesive, hair spray, after shave, perfume, auto exhaust
(cold start) and some cleaning agents.
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help
2549-7201-01_EN.qxp__ 15-6-1 下午1:37 16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kidde KN-COP-DP-10YB and is the answer not in the manual?

Kidde KN-COP-DP-10YB Specifications

General IconGeneral
BrandKidde
ModelKN-COP-DP-10YB
CategorySecurity System
LanguageEnglish

Related product manuals