page 7:15
Prepare the locking strip
If
there is a Skirting/Base Board on the wall to which
the locking strip is to be attached, a piece of wood,
the thickness of the Skirting Board, will need to be
positioned between the locking strip and the wall, at the
ATTACHING THE LOCKING STRIP
- 13 -
7
English
6
(a)
(b)
Drill five holes at the points marked on the
locking strip according to Fig. 6a or Fig. 6b
Attaching the locking strip
Release and pull out the gate, see ‘How to operate’,
Fig. 8.
Hook the locking rod onto the locking strip, and
hold it against the wall/banister against which it
is to be mounted. Make sure that the mesh is evenly
Attach the locking strip to the wall by marking
through the holes of the locking strip to identify where
screw holes should be drilled. See fig. 4 to determine
how to screw the locking strip to different wall materials.
6a) When mounting locking strip TO THE
WALL according to Fig. 1a or 1b
6b) When mounting locking strip WITHIN
THE OPENING according to Fig 1c
stretched across the opening.
top of the locking strip.
To Next Page
Loading...