• Routinely inspect the product for all damaged parts and the security of screws, nuts,
etc.
• Do not install any objects [to the product] which could be dangerous to its proper
performance or any objects that could injure children.
• If damage is found, discontinue use immediately and keep the product out of child’s
reach until the product is repaired.
• Do not use the product in any manner not specified in the manual.
• It is unacceptable to use the scooter on roads where there is traffic, or any other
roads on which motor vehicles travel and other places that pose a risk to the health
and life of children.
• Do not operate the product on surfaces that are wet, slippery, sandy, gravely, etc.
which can cause the risk of losing balance.
• Do not operate the product after dark, in mist or other weather which reduces
visibility.
• The safest areas to ride the scooter are areas with limited or no motorized traffic,
such as private areas, recreational areas, playgrounds, school fields.
• Before using this product, make sure that the child understands how to operate it
correctly - especially how to make turns and stop the scooter.
• Do not leave the product exposed to train, snow or heat.
• This product must be assembled by adults.
• Failure to take precautions will expose the user to the hazards associated with the
product as specified by the manufacturer.
• The toy must be kept out of reach of children under the age specified by the
manufacturer.
The product complies with the requirements of European Union directives.
In accordance with Directive 2012/19/EU, this product is subject to separate
collection. The product should not be disposed of with municipal waste as
it may pose a risk to the environment and human health. Return the used
product to the recycling center for electrical and electronic equipment.
The manufacturer declares the compliance of the device with the European
Parliament and Council Directive 2009/48/WE of 18 June 2009 on safety of
toys and harmonized standards: EN71-1, EN71-2, EN71-3.. The device
was marked as a result of carrying out a conformity assessment
procedure.
To Next Page
Loading...