STEERING
The turning function of the kick scooter takes place by tilting the steering column to the
sides. The steering column should not be able to be rotated
BRAKE
The rear fender also serves the function of a brake. The rear fender must be stepped on
in order to initiate the process of braking of the kick scooter.
WARNING: Stepping on the rear fender brake with the entire body weight while travelling
at higher speeds can result in an abrupt halt of the kick scooter, loss of balance and
injury.
ADJUSTMENT
In order to adjust the height of the steering column open the cap on the steering column
below the handle grip by turning it around.
Press the blocking bolt so that it does not stick out above the surface of the steering
column and push down or pull up the steering column to find one of the available desired
heights until, the blocking bolt jumps into one of the openings on the side of the steering
column and appears above its surface.
In order to fully secure the steering column, close the cap back on located below the
hand grip by turning it around.
WARNING: after setting the appropriate height of the steering column for the child,
make sure that the blocking bolt is sticking out above the surface of the steering column
which means that the lock is activated and that the cap is closed properly.
LIMITATIONS OF WARRANTY
The warranty does not cover destruction or loss of individual elements due to falling,
abrasion, incorrect assembly and use which is not in accordance with the user manual.
To Next Page
Loading...