To Next PageTo Next Page
Need help?Do you have a question about the Kikusui PAD-L III Series and is the answer not in the manual?
General| Brand | Kikusui |
|---|---|
| Model | PAD-L III Series |
| Category | Power Supply |
| Language | English |
Details the acceptable input voltage range and specifications for the unit.
Specifies the rating and type of input fuse required for the unit.
Information regarding the provided AC power cords and their connection.
Explains the meaning and significance of safety symbols used in the manual and on the product.
Guidelines for safe operation and intended use by qualified personnel.
Precautions for installing the unit in suitable environments and securing it properly.
Safety measures during operation, relocation, maintenance, and service procedures.
Outlines the organization of the manual, listing its chapters and their content.
Provides an introduction to the manual and its scope.
Lists the specific PAD-L series models covered in this manual.
Details brackets and blank panels for integrating TYPE III models into racks.
Details brackets and blank panels for integrating TYPE IV models into racks.
Details necessary accessories and checks upon receiving the product.
Explains precautions for installing the power supply safely, including environmental considerations.
Outlines safety precautions and procedures for moving the power supply.
Details the procedure for changing the input voltage on TYPE III models.
Provides instructions for safely connecting the AC power cord.
Explains the importance and procedure for proper grounding of the power supply.
Discusses inrush current phenomena and precautions when powering on the unit.
Explains the phenomenon of negative output voltage and its implications.
Addresses potential output instability with various load types like pulsed or regenerative loads.
Explains the constant voltage (CV) and constant current (CC) operation modes.
Details the various protective circuits built into the PAD-L series units.
Explains the procedures and safety considerations for grounding output terminals.
Step-by-step procedure for turning on the unit and checking operating conditions.
Covers operating the unit in CV and CC modes, including OVP presetting.
Covers connecting load cables and to the output terminals.
Instructions on how to mount and use guard caps for setting knobs.
Explains the remote sensing function to stabilize output voltage at the load terminal.
Covers controlling output voltage remotely using external resistors or voltage sources.
Methods for controlling output ON/OFF using external contacts.
Covers controlling output current remotely using external resistors or voltage sources.
Connects up to two slave units in parallel to increase current capacity.
Connects multiple units in series to increase output voltage.
Procedure for shutting off the power switch using external contact.
Example application for charging batteries or capacitors at constant current.
Identifies and describes controls and indicators on the front panel of PAD-L series models.
Identifies and describes ports and terminals on the rear panel of PAD-L series models.
Instructions for cleaning the unit's panels.
Guidelines for inspecting the unit, including the AC power cord.
Covers required equipment, environment, cover removal, and detailed voltage/current system adjustments.
Instructions for replacing the input fuse on specific models.
Lists common malfunctions and their potential causes and remedies.
Detailed electrical and mechanical specifications for TYPE III PAD-L models.
Detailed electrical and mechanical specifications for TYPE IV PAD-L models.
Detailed electrical and mechanical specifications for TYPE V PAD-L models.
