To Next PageTo Next Page
Need help?Do you have a question about the Kikusui PWX750MLF and is the answer not in the manual?
General| Output Power | 750 W |
|---|---|
| Input Voltage | 100 to 240 VAC |
| Input Frequency | 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 70°C |
| Humidity | 20 to 85% RH (No condensation) |
| Protection Features | Overvoltage, overcurrent, overtemperature |
| Interface | USB |
Identification and description of the front panel controls and indicators.
Identification and description of the rear panel connectors and indicators.
Instructions for connecting the AC power cord to the PWX series unit.
Procedure for safely powering the PWX series unit on and off.
Guidance on installing the PWX series unit into a rack mount.
Important factors to consider when connecting loads to the PWX series.
Guidelines for selecting and using appropriate load cables for the PWX series.
Steps for safely connecting cables to the output terminals of the PWX series.
Explanation of local and remote sensing functions for voltage accuracy.
Describes the different display modes for voltage, current, and settings.
Details on using the front panel controls for voltage and current adjustment.
How to turn the output on and off using the front panel and startup settings.
Explains constant voltage (CV) and constant current (CC) operation modes.
Detailed explanation of CV and CC modes and crossover points.
Step-by-step guide to setting up PWX for CV or CC operation.
Overview of protection functions like OVP, OCP, and alarm handling.
Guide to configuring system parameters and settings via the CONFIG menu.
How to save and recall output settings using the preset memory feature.
Functionality to lock the front panel controls to prevent accidental changes.
How to enable or disable the internal bleeder circuit.
Procedure to switch between front panel control and remote control.
How to reset the PWX series to its factory default configuration.
Introduction to external control and details of the J1 connector.
Safety guidelines for output terminal insulation and grounding practices.
How to control output voltage using external voltage or resistance.
How to control output current using external voltage or resistance.
Using external contacts to manage output on/off states.
Using external contacts for output shutdown control.
Using external contacts to clear alarms.
Monitoring PWX operational status and output values externally.
Instructions for connecting and configuring multiple PWX units in parallel.
Guidance on connecting and operating PWX units in series for higher voltage.
Procedures and requirements for calibrating the PWX series unit.
Technical specifications for the 750W models of the PWX series.
Technical specifications for the 1500W models of the PWX series.
Details on the optional isolated analog interface for external control.
Description of the factory option for simulating internal resistance.
Information on available optional accessories for the PWX series.
Common issues and their solutions for the PWX series.
