3
4
KK
J
STEP 10:
Adjust balance of the full chair, then tighten all bolts to
100% on each side of adjuster.
STEP 11:
Attach the Plastic Cover on right and left side with four
M5*8mm bolts, using the wrench.
STEP 9 :
Attach Seat Cushion and Back Cushion, align the adjusters
over the pre-drilled holes underneath the back cushion with M8x25mm
Bolts, tighten all the bolts with the wrench.
Note: Please tighten the Bolts to 50%, not 100%.
E
F2
4
E-mail: service@killabee.net Web: www.killabee-gaming.com
9
ASSEMBLY INSTRUCTIONS
To Next Page
Loading...
