© 2020 UTC Fire & Security. All rights reserved. 1 / 12 P/N 10-4221-501-KL7C-02 • ISS 06FEB20
KL710 and KL731 Conventional Point Detector
Installation Sheet
EN DE ES FR HU IT NL PL PT TR
EN: Installation Sheet
Installation
Caution: For general guidelines on system planning, design,
installation, commissioning, use, and maintenance, refer to the
EN 54-14 standard and local regulations.
To install a detector
1. Insert the detector head into the mounting base and rotate
it clockwise until it clicks into place (Figure 1).
2. The detector may be locked into the mounting base if
required. To do this, remove the locking tab before
installation (Figure 2).
3. Always test detectors after installation.
To remove a locked detector:
1. Insert a small screwdriver into the locking tab slot
(Figure 3).
2. Press and rotate the detector anticlockwise.
Maintenance
Basic maintenance consists of a yearly inspection. Do not
modify internal wiring or circuitry.
To Next Page
Need help?
General
