Kimessa CANline 04 User Manual


Operating Instructions
CANline 04
Alarm and Control system
Copyright © 2015 by KIMESSA –Switzerland
All rights are reserved by KIMESSA. Any reproduction, whether in hard or digital copy, even in part, without
written permission of KIMESSA-Swiss in any design and shape is prohibited.
The information in the documents are created according to current knowledge. Due to ongoing product deve-
lopments, technical changes or deviations may occur.
KIMESSA AG
Tel.: +41 (0)44 404 38 38
Rautistrasse 12 Fax: +41 (0)44 404 38 39
CH-8047 Zurich / Switzerland   Email info@kimessa.com
Home www.kimessa.com





Kimessa CANline 04 Specifications

General

Brand	Kimessa
Model	CANline 04
Category	Security System
Language	English

Summary

General Information

Warning

Product focus on safety and sensor technology for gas hazard protection.

Risk and Potential Hazard

Identifies hazards from improper use, unauthorized operation, and lack of maintenance.

Target Group and Personal Protective Equipment

Defines intended users, required skills, and mandatory personal protective equipment.

Installation

Conditions of Use and Mounting

Specifies environmental, location, and mounting requirements for the control unit.

Electrical Installation, EMC and ATEX

Details electrical installation, EMC, and ATEX compliance for safe operation.

CANline 04 Connections

Wiring Schematic for 4 x 4..20mA Detectors

Provides the electrical diagram for connecting 4-20mA gas detectors to the unit.

Wiring Schematic for Realy Contacts (Standard)

Commissioning

Commissioning Tools and Connection Check

Programming by Software

Menu Item: Firmware Update

Menu Item: Sensors Configuration

Menu Item: Relays Configuration

Menu Item: Timers Configuration

Button Programming

Faults, Causes and Solutions