By–pass
There may be times when you need to shut off the water supply to your
entire house. To do this, set the by–pass valve to the “OFF” position. No
water will flow through the house.To restart the water, set the by–pass valve
to the “SERVICE” position.You may put the softener into by–pass at any
time, if necessary, by putting the by–pass valve into the “BY–PASS” posi-
tion.You will still get water throughout the house; however, all of the water
will be untreated.To return the softener to service, set the by–pass valve to
the “SERVICE” position.
NOTE: By–pass styles vary, and yours may not be as described. Contact your
Kinetico dealer for further assistance.
To Next Page
Loading...
Need help?
General
