MAINTENANCE
1). Periodically check and maintain proper gear oil level.
2). Every 8 hours, grease spindles (3), roller axle (1), wheel forks (4), wheel
axles (4), PTO shaft universal joints (2), and PTO telescoping surface.
NOTE: Use only a grade Type II tube grease.
3). Keep tires inflated to rated PSI (listed on tire) at all times.
4). Before each use check to make sure all safety features are installed and
working properly.
5). Keep blades sharp and balanced at all times. When replacing blades,
replace all 3 blades and blade bolts at the same time.
NOTE: Blade bolts are left hand thread!
6). Periodically check all nuts, bolts, and belt to insure they are tight and
secure.
21
Figure C
(grease points at arrows)
To Next Page
Loading...
Need help?
General
