1.Enter programming mode (*1234), a long Di sound.
2.Enter 2 digits position from 01-40, a long Di sound.
Press # , another Di sound again. means delete it.
3.Press * to exit.
1.Enter programming mode (*1234), a long Di sound.
2.Press #, DiDi sound, press # one more time, a long Di sound, press # 7 times,
after 3 seconds, a long Di sound , means deleting success. After that, the
unlock time delay changes to 1 second , and clear out all user passwords, but
programming password no change(1234).
3.Press * to exit.
Switch off power , press # and keep holding, switch on the power.
After a long Di sound , release #, means restoring success.
The default programming password is 1234 , and clear out all the user passwords.
Delete one user password(input position)
Delete user password(input user password)
1.Enter programming mode (*1234), a long Di sound.
2.Press # , DiDi sound, enter that 4 digits password you want to delete
(can be 2-6digits). After a long Di sound, means deleting success.
3.Press * to exit.
1.Enter programming mode (*1234), a long Di sound.
2.Enter 2 digits position from 01-40, a long Di sound.
3.Press 4 digits password(2-6 digits),after a long Di sound, means add success.
4.Press * to exit.
Delete all settings
Restore factory mode
Add user passwords
Attention:each door station keypad have 40 positions(01-40), each position
allow one password.Position 31-40 cant set unlock delay, beacuse there’re
used for dry contact lock(NO/NC).
-11-
To Previous Page
Loading...