6. Slide the wheel axle into the pressure
washer housing.
(Note: If wheel axle does not slide
easily try sliding wheel axle through the
other side of pressure washer housing
or try greasing the axle.)
FIG. 12
7. On the other side of the pressure
washer housing pull the wheel axle all
the way out.
FIG. 13
8. Place the wheel on the axle that is
sticking out from the pressure washer
housing.
FIG. 14
9. Attach wheel clip to other side of wheel
axle. Tighten wheel clip. A click sound
indicates that the wheel is secured.
FIG. 15
11
To Next Page
Loading...