32
FPPBC25-6
In more detail . . .
> Avoid cutting tall grass in one cut. Trim taller grass in stages (Fig. 25).
25
> Hold the cutting attachment just above the ground at an angle of approximately 30°
(Fig. 26).
>
Move the machine with slow and regular motion from left to right before moving it
back to the starting position and trimming the next area (Fig. 27).
26
27
30°
> Ensure that the cutting attachment remains clean and
free of off-cuts to avoid jamming. Make sure the stop
switch (20) is set to I and the spark plug connector (3)
is removed before checking the cutting attachment
for defects.
>
Avoid cutting wet grass as it tends to stick to the moving
parts.
> Pay special attention when performing the work close
to trees and bushes (Fig. 28).
28
Operation
To Next Page
Loading...