33
FPPBC25-6
In more detail . . .
Care and maintenance
After use
1.
Stop the engine, disconnect the spark plug connector and let the engine cool down.
2. Check, clean and store the machine as described below.
WARNING! The cutting attachment continues to rotate for some time
after the engine has been switched off. Wait until the cutting attachment
comes to a complete stop before setting the machine on the ground.
The golden rules for care
WARNING! Always stop the engine, disconnect the spark plug connector (3)
and let the engine cool down before performing inspection, maintenance and
cleaning work.
DANGER! Proper maintenance is essential for safe and trouble free operation.
Improper maintenance, or failure to address a problem instantly can cause a
malfunction which can result in serious injury or even death.
1. Keep the machine clean. Remove debris after each use and before storage.
2.
Regular and proper cleaning helps to ensure safe operation and prolongs the life
of the machine.
3. Inspect the machine before each use for worn and damaged parts. Do not operate
it if you nd broken and worn parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the machine again.
WARNING! Only perform repairs and maintenance work according to these
instructions! All other works must be performed by a qualied person!
Cleaning
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this machine as they might be harmful to its surfaces.
Cleaning the housing
> Use a damp, lint-free cloth to clean the housing.
> Do not emerge the machine into water or any liquids.
To Next Page
Loading...