Kingfisher FPPBC25-6 - Page 34

34
FPPBC25-6
In more detail . . .
> Clean the ventilation openings (9) on the bottom and at the side cover of the engine
with a soft brush. Clogged ventilation openings (9) might cause the engine to overheat.
> Wipe the surface with a dry cloth afterwards.
Cleaning the cutting attachment
> Disassemble the cutting attachment in reversed order from assembly.
> Use compressed air (max. 3 bar) to remove dirt accumulated on the cutting attachment.
> Use a damp, lint-free cloth to clean the surface.
> Wipe the surface with a dry cloth afterwards.
Maintenance table
Inspect and maintain this machine regularly based on below maintenance table. Keep
the machine in good working condition during maintenance.
Part Task Before/after
each use
Every 10 hours
of operation
Every 25 hours
of operation
Spark plug
check X
clean X
replace whenever necessary
Air lter
check X
clean X
replace whenever necessary
Fuel lter
and fuel
lines
clean whenever necessary
replace whenever necessary
Cutting
attachment
check X
lubricate X
clean X
replace whenever necessary
Care and maintenance