Kingfisher FPPBC25-6 - Page 35

35
FPPBC25-6
In more detail . . .
Cutting line
If the cutting line is used up, either the spool must be replaced by one of the same type
or the cutting line must be relled.
Before replacing the spool or the cutting line:
1. Lay the machine on a at stable surface with its
spool assembly facing upwards.
2. Open the spool assembly by unscrewing the
bumper in a clockwise direction (Fig. 29).
To replace the spool:
1. Remove the old one from the spool assembly.
2. Replace with a new one of the same type.
To replace the cutting line:
1. Take out the old spool and remove the remaining cutting line.
2. Cut a new 6 meter long cutting line with a diameter of 2 mm.
3. Form a loop at the middle of the line and insert this loop into the hook on the
spool.
4. Wind the two parts of the cutting line clockwise rmly around the spool (Fig. 30).
Refer to the arrow of “WIND CORD” marking on the spool for the winding
direction.
5. Place the spool into the spool assembly and pass each end of the cutting line
through the respective holes (Fig. 31).
6. Pull both ends of the cutting line so there is about 15 cm of loose cutting lines.
7. Ret the bumper and turn it in an anti-clockwise direction to secure the parts in
place, pressing the spool towards the spool assembly.
30 31
WARNING! After changing the cutting line, run the machine under no load
for at least a minute to make sure that the line was installed properly and the
machine operates correctly.
29
Bumper
Spool
Care and maintenance