7
8. When servicing the blades be aware that, even though the
power source is switched off, the blades can still be moved.
9. Replace worn or damaged parts for safety. Use only genuine
replacement parts and accessories.
10. Wear strong work gloves when removing and reassembling the
cutting blade.
11. Have the product repaired only by an authorized service centre
or similar qualied specialist.
12. When not in use, store the product out of the reach of children.
13. The product should be supplied via a residual current device
(RCD) with a tripping current of not more than 30mA.
14. If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service
agent.
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the
time of operation, use low-vibration and low-noise operating
modes as well as wear personal protective equipment.
Take the following points into account to minimize the vibration and
noise exposure risks:
• Only use the machine as intended by its design and these
instructions.
• Ensure that the machine is in good condition and well maintained.
• Use correct attachments for the machine and ensure they are in
good condition.
• Keep tight grip on the handles/gripping surface.
• Maintain this machine in accordance with these instructions and
keep it well lubricated (where appropriate).
• Plan your work schedule to spread any high vibration tool use
across a longer period of time.
5059340880747_MNL_EN_V03.indd 75059340880747_MNL_EN_V03.indd 7 16/11/2023 6:24 PM16/11/2023 6:24 PM
To Next Page
