MAINTENANCE
1). Periodically check and maintain proper gear oil level.
2). Every 8 hours, grease wheel forks (4), wheel axles (4), PTO shaft univer-
sal joints (2), and PTO telescoping surface.
NOTE: Use only a grade Type II tube grease.
3). Before each use check to make sure all safety features are installed and
working properly.
4). Keep blades sharp and balanced at all times. When replacing blades,
replace both blades and blade bolts at the same time.
5). Periodically check all nuts, bolts, and all safety guards to insure they are
tight and secure.
22
Figure E
(grease points at arrows)
To Next Page
Loading...
