To Next PageTo Next Page
Need help?Do you have a question about the Kingspan Tribune HE Series and is the answer not in the manual?
General| Model | Tribune HE Series |
|---|---|
| Type | Unvented Cylinder |
| Heat Source | Indirect |
| Material | Stainless Steel |
| ErP Rating | A |
| Energy Source | Electric |
| Efficiency | High |
| Insulation | High-density polyurethane foam |
| Warranty | 25 years on cylinder |
Lists all components supplied with the unvented cylinder for easy identification.
Checks and considerations for the mains water supply pressure and flow rate required for the cylinder.
Requirements for the 240V electrical supply, including fused connections and cable specifications.
Recommendations for the optimal placement of the cylinder, considering access, frost protection, and orientation.
Considerations for ensuring adequate space for inspection, maintenance, and servicing of the cylinder.
Guidance on routing and connecting the cold water mains supply pipework to the cylinder.
Details on connecting the pipework, gland nuts, and olives for the cylinder connections.
Instructions for connecting primary circuits for indirect heating systems, including boiler and heat pump integration.
Information on the type, rating, and installation of immersion heaters, including safety cut-outs and replacement advice.
Details on how to correctly route discharge pipes from safety valves to a safe termination point.
Details the construction materials used for the cylinder, including Duplex stainless steel and insulation.
Provides technical specifications for the immersion heater, including thread type and rating.
Outlines the guarantee period for the cylinder and its parts, including registration requirements.
Illustrates the connections and dimensions for direct unvented cylinder models.
Provides connection diagrams and measurements for indirect pre-plumbed cylinder models.
Illustrates connection points and dimensions for solar indirect pre-plumbed cylinder models.
Illustrates connections and dimensions for cylinders designed for heat pump and solar applications.
Wiring diagram for single zone heating and hot water systems using programmable thermostats.
Wiring diagram for twin zone heating and hot water systems with dual thermostat controls.
Schematic diagrams for wiring solar systems with high limit controls for safety.
Wiring configurations for dual thermostat setups, including S-Plan and Y-Plan systems.
Procedures for filling the cylinder, checking connections, and flushing the system to remove debris.
Essential safety checks during heat-up, including leak detection and testing of safety valves.
Commissioning steps specific to direct heated unvented cylinders, including thermostat adjustment.
Commissioning procedures for indirect units, covering primary circuit flushing and thermostat settings.
Step-by-step instructions for safely draining the cylinder, including important warnings about hot water.
Requirements for annual servicing to ensure safe operation, optimum performance, and guarantee validity.
Guidance for homeowners on normal operation, annual servicing, and fault identification.
Refers homeowners to the insert sheet for detailed performance specifications of their cylinder.
Explains the importance of the Benchmark Scheme for installation, commissioning, and homeowner guarantees.
