EasyManua.ls Logo

Kingspan Range Tribune HE User Manual

Kingspan Range Tribune HE
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Renewables
Issue 16 April 2012
Tribune HE Unvented Hot Water Cylinders
Installation and Maintenance Instructions
IMPORTANT NOTE TO THE INSTALLER
Read these instructions before commencing installation. Unvented


The relevant regulations are: England and Wales – Building Regulation G3, Scotland – Technical
Standard P3, N Ireland – Building Regulation Part F
After installation the Benchmark Log Book must be completed and left,
with these instructions, with the householder for future reference.
All manuals and user guides at all-guides.com
all-guides.com
Question and Answer IconNeed help?

Do you have a question about the Kingspan Range Tribune HE and is the answer not in the manual?

Kingspan Range Tribune HE Specifications

General IconGeneral
BrandKingspan
ModelRange Tribune HE
CategoryWater Heater
LanguageEnglish

Summary

Tribune HE Unvented Hot Water Cylinder Installation and Maintenance

Important Note to the Installer

Crucial advice for installers before commencing installation.

Product Handling, Storage & Supply

Storage Prior to Installation

Guidance on storing the unit correctly before installation.

Handling Product

Instructions for safe and proper handling of the cylinder.

Water Supply Requirements

Information on mains water pressure and flow rate for optimal performance.

Electrical Supply Requirements

Details on the necessary electrical connection and cable specifications.

Unpacking the Unit

Overview of unit contents and unpacking procedures.

Siting the Unit

Schematic Diagram

General Installation Procedures

Cold Mains Pipework

Instructions for connecting the cold water supply pipework.

Connecting to the Cylinder

Details on making pipework connections to the cylinder body.

Balanced Cold Connection

How to provide a balanced cold supply for specific fittings.

Hot Water Pipework

Guidance on installing the hot water distribution pipework.

Primary Coil Connections

Instructions for connecting indirect heating primary circuits.

Secondary Circulation

How to install a secondary circulation system.

Immersion Heaters

Information on installing and wiring immersion heaters.

Electrical Connections

Guidance for completing electrical wiring based on diagrams.

Discharge Arrangement

Technical Specifications: Slimline Models

Technical Specifications: Direct & Indirect Models

Technical Specifications: Ecocyl Models

Technical Specifications: Solar Models

Solar Unvented Cylinder Installation Guide

Wiring Diagrams: Solar High Limit Control

Wiring Diagrams: S-Plan System

Wiring Diagrams: Y-Plan System

Wiring Diagrams: Pre-Plumbed Single Zone

Wiring Diagrams: Pre-Plumbed Twin Zone

Pre-Plumbed Cylinder Installation

Installation Procedures

Step-by-step guidance for installing pre-plumbed cylinder units.

Connections for Indirect and Solar

How to connect indirect heating and solar coil systems.

Technical Specifications: Pre-Plumbed Models

Commissioning and Servicing Procedures

Flushing, Filling & Unit Commissioning

Procedures for flushing, filling, and commissioning direct/indirect units.

Safety Valve Checks and Annual Maintenance

How to test safety valves and perform annual servicing.

Fault Finding and User Instructions

Troubleshooting Common Faults

Common faults, their causes, and solutions for troubleshooting.

General User Guidance

Basic operational advice and information for users.

Kingspan Guarantee and Warranty Terms

Technical Specifications: Pressure and Element Data

Cylinder Details and Performance Specification

Related product manuals