1.Press “power switch” for short time, panel power on., long press “power switch”, panel power off.
2.Press “Wind speed+” to increase the air volume; Press “Wind speed-” to reduce the air volume;
3.Press “Temperature+” to rise setting temperature value; Press “Temperature-” to lower setting temperature
value;
4.Press “Mode key”, Cyclic switching four modes: air supply, strong, energy saving and sleep.
5.Undervoltage and recovery value adjustment: long press “mode key”, enter into undervoltage mode setting.
Press “Wind speed+” increase low-voltage protection value, press “Wind speed-” to reduce low-voltage
protection
value;
Press “Temperature+” to increase low-voltage protection recovery value, press “Wind speed-” to reduce low-
voltage
protection recovery value;
1. 16 Power switch: Press this key to boot, long press 3 seconds to shut down; In the shutdown state, press
and hold for 10 seconds to restore all settings to the factory settings, and switch between Fahrenheit and
Celsius display .
2. 15 Wind speed+ : Increase the air volume and increase the low-voltage protection value.
3. 14 Wind speed-: Reduce he air volume and reduce the low-voltage protection value.
4. 8 Mode key: Cyclic switching four modes: air supply, strong, energy saving and sleep; Power on state,
press and hold for 6 seconds to enter the voltage setting.
5. 10 Temperature+: rise temperature, increase the low- voltage protection recovery value.
6. 12 Temperature-: lower temperature, reduce the low- voltage protection recovery value.
To Next Page
Loading...