The device is suitable for use in all
establishments other than domestic and
those directly connected to the public low
voltage power supply network that supplies
buildings used for domestic purposes.
Harmonic
emissions
IEC 61000-3-2
Voltage fluctuations/
Flicker emissions
IEC 61000-3-3
Electromagnetic
Environment - Guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
± 8 kV
contact
± 2 kV,
± 4 kV,
± 8 kV,
± 15 kV air
± 8 kV
contact
± 2 kV,
± 4 kV,
± 8 kV,
± 15 kV air
Floors should be wood,
concrete, or ceramic tile. If floors
are covered with synthetic
material, the relative humidity
should be at least 30%
Power
frequency
(50Hz/60Hz)
magnetic field
IEC 61000-4-8
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital
environment.
Magnetic fields from common
appliances are not expected to
affect the device.
NOTE: UT is the a.c. mains voltage prior to application of the test level
Radiated RF
IEC 61000-4-3
10V/m
80MHz to
2.7GHz
9V/m,
27V/m,
28V/m
385-5785
MHz
10V/m
80MHz to
2.7GHz
9V/m,
27V/m,
28V/m
385-5785
MHz
Portable RF communications
equipment (including peripherals
such as antenna cables and
external antennas) should be
used no closer than 30 cm (12
inches) to any part of the device,
including cables specified by the
manufacturer. Otherwise,
degradation of the performance
of this equipment could result.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
To Next Page
Loading...
