Kioritz Echo SRM-2305 User Manual

SRM-2305, SRM-2305SI10-21L-01
1
INTRODUCTION
We are constantly working on technical
improvement of our products. For this reason,
technical data, equipment and design are
subject to change without notice. All
specifications, illustrations and directions in
this SERVICE DATA are based on the latest
products information available at the time of
publication.
1
CONTENTS
page
1 SERVICE INFORMATION ............................. 2
1-1 Specification ............................................... 2
1-2 Technical data ............................................ 3
1-3 Torque limits ............................................... 4
1-4 Special repairing materials ........................ 4
1-5 Service limits .............................................. 5
1-6 Special tools ............................................... 6
2 EMISSION ADJUSTMENT GUIDE ............... 7
2-1 General adjusting rules .............................. 7
2-2 Presetting idle adjust screw, L mixture needle
and H mixture needle ........................................ 7
2-3 Adjusting carburettor .................................. 8
Reference No. 10-21L-01
R E V I S E D : 2 0 0 5 0 2
INDEX
ISSUED: 200410

Kioritz Echo SRM-2305 Specifications

General

Brand	Kioritz
Model	Echo SRM-2305
Category	Brush Cutter
Language	English

Summary

1 SERVICE INFORMATION

1-1 Specifications

Detailed technical specifications for SRM-2305 and SRM-2305SI models, including dimensions, engine, and fuel.

1-2 Technical data

Key technical performance data including engine speeds, pressures, and carburetor settings.

1-3 Torque limits

Recommended torque values for various fasteners, components, and assembly points.

1-4 Special repairing materials

List of recommended adhesives, thread locking sealants, and greases for repairs.

1-5 Service limits

Maximum or minimum allowable dimensions for checking wear on engine components.

1-6 Special tools

List of specialized tools required for performing maintenance and repair tasks.

2 EMISSION ADJUSTMENT GUIDE

2-1 General adjusting rules

Pre-adjustment checks and general guidelines for emission control adjustments.

2-2 Presetting Idle Adjust Screw, L Mixture Needle and H Mixture Needle

Initial settings for carburetor idle adjust screw, L mixture, and H mixture needles.

2-3 Adjusting carburettor

Step-by-step procedure for adjusting the carburetor for optimal performance and emissions.