10
-22 CK22
REPLACING FUEL FILTER
ELEMENT
(A) Wheel - to - wheel distance at front
(B) Wheel - to - wheel distance at rear
ADJUSTING TOE-IN
(1) Lock Nuts (2) Tie Rod
ADJUSTING PROCEDURE
1. Loosen the lock nut and turn the turn-
buckle to adjust the rod length until
the proper toe-in measurement is
obtained.
2. Retighten the lock nut.
1. Park tractor on a flat place.
2. Turn steering wheel so front wheels
are in the straight ahead position.
3. Lower the implement, lock the park-
ing brake and stop the engine.
4. Measure distance between tire beads
(center) at front of tire, hub height.
5. Measure distance between tire
beads at rear of tire, hub height.
6. Front distance should be 0.079 ~ 0.
315 in.(2 ~ 8 mm) less than rear
distance. If not, adjust tie rod length.
051OA37C
EVERY 300 HOURS
(1) Fuel Cock
(2) Fuel Filter Bowl
(3) O-Ring
(4) Filter Element
(5) Screw Ring
(A) Close
(B) Open
051OA38C
051OA36C
To Next Page
Loading...
