7
-2 CK22
Operating the position control lever ac-
tuates the hydraulic lift arm. This con-
trols the elevation of the 3-point hitch
mounted implement.
3-POINT HITCH CONTROL SYSTEM
HYDRAULIC CONTROL
051O701C
If the 3-point hitch can not be
raised by setting the hydraulic
control lever to the “UP” posi-
tion after long term storage or
when changing the transmission
oil, follow these air bleeding
procedures.
1. Stop the engine.
2. Set the hydraulic control le-
ver to the “DOWN” position
and start the engine.
3. Operate the engine at low
idle speed for at least 30 sec-
onds to bleed air from the
system.
Do not operate until the engine
is warmed up. If operation is at-
tempted when the engine is still
cold, the hydraulic system may
be damaged.
If noises are heard when imple-
ment is lifting after the hydrau-
lic control lever has been
activated, the hydraulic mecha-
nism is not adjusted properly.
Unless corrected the unit will be
damaged. Contact your KIOTI
dealer for adjustment.
IMPORTANT
(1) Hydraulic Control Lever
(A) DOWN (B) UP
To Next Page
Loading...
