MAINTENANCE 6-13
A12O616A
1. To drain the used oil, remove the right
and left drain plugs and filling plug at
the front axle case and drain the oil
completely into the oil pan.
2. After draining reinstall the drain plugs.
3. Remove the oil level check plug.
4. Fill with the new oil up to the check
plug port.
(See “LUBRCANTS” in Maintenance
Section)
5. After filling reinstall the filling plug and
check plug.
Oil Capacity
8.2
(2.2 U.S.gal.)
(1) Filling Plug (3) Drain Plug
(2) Oil Level Check Plug
CHANGING FRONT AXLE CASE OIL
A12O617A
(1) Brake Pedal
(A) 25 ~ 40mm (1.0 ~ 1.6 in.)
CAUTION
To avoid personal injury:
Stop the engine and chock the
wheels before checking brake
pedal.
Proper
brake pedal
free travel
25 ~ 40 mm
(1.0 ~ 1.6in.)
on the pedal.
Keep the free travel
in the right and left
brake pedals equal.
1. Release parking brake.
2. Slightly depress the pedals and mea-
sure the free travel at the top of the
pedal stroke.
3. When adjustments are needed, loosen
the locking nut and turn the turnbuckle
until the rod length is at the desired
and acceptable limit.
4. Re-tighten the lock nuts.
ADJUSTING BRAKE PEDAL
To Next Page
Loading...
