DESCRIPTION OF OPERATING SYSTEM 4-29
WIPER
(1) Wiper Operating Switch (Front)
(2) Wiper Operating Switch (Rear)
(3) Wiper Front
1. To turn on, position the switch marked
(wiper) to the “ON” position.
2. When you press the ON direction of
the switch, wash fluid will spray from
the nozzle connected to the wind-
shield wiper.
3. The tank for the washer fluid is
equipped on the left side behind the
seat.
WARNING
You may use general tap water as
the washing fluid. But it is better
to use the washer fluid for auto-
mobile if possible. You have to
use it especially in winter.
If you operate the windshield
wiper without the washer fluid, it
will damage the motor. Therefore,
you should check the washing
fluid before operation.
Do not wash the windshield with
the wiper if it is covered by mud.
Please spray the washing fluid
during the operation of the wiper.
And if you operate the wiper with
the window frozen in winter, the
internal fuse will may short
circuit. Please operate the wiper
after raising the temperature in
this case.
A12O450A
A12O451A
HEATER
(1) Heater Switch
HEATER SWITCH
Turning the switch to “LOW” or “HIGH”
operates it.
WARNING
After driving with warm air, place
the heater switch at “LOW”
position. Wipe off the indoor win-
dow if it becomes blurred.
Make sure that nothing will block
the entrance of the heater grill. It
is the cause of fault.
DK451
DK501/551
To Next Page
Loading...
