8. Run the start motor for approx.
10 seconds to distribute oil to
each part of the engine.
9. Run the engine for approx. 5 mi-
nutes and check for proper opera-
tion through the engine oil warning
lamp. Then, stop the engine. (It is
normal that the oil warning lamp is
off while the engine running)
10. Check the engine oil level again
with the oil dipstick. If the level is
low, add more oil.
NOTE
The engine oil filter should be
replaced when changing the en-
gine oil.
•
IMPORTANT
Use only specified engine oil
and KIOTI genuine filter to
insure smooth operation and
durability of the engine.
•
WARNING
The engine oil is very hot while
the engine is running or right
after the engine is stopped. Be
careful not to be burnt.
Avoid oil contact while chan-
ging or adding engine oil and
wear eye protection to prevent
eye contact.
Prolonged and repeated con-
tact with the engine oil may
ca u s e s k in di s orde r s a n d
skin cancer. If skin contact is
made, wash thoroughly with
soap or hand cleaner as soon
as possible.
Keep the used oil out of reach
of children.
•
•
•
•
CAUTION
To avoid injury:
Be sure to stop the engine be-
fore changing the uid or repla-
cing the lter.
Check the engine oil level befo-
re every operation of the tractor.
If the engine oil is insufcient,
the engine can be damaged,
and this is not covered by war-
ranty. Be sure to add the engine
oil when its level is below the
lower limit of the oil dipstick.
Do not dispose of used oil and
oil lter into drainage and other
places not designated by regu-
lations. Observe applicable re-
gulations when disposing used
oil and lters.
•
•
•
To Next Page
Loading...
